This harness connects to your factory wiring and provides the wires needed to install an aftermarket radio. It includes a CAN BUS interface that translates the data signals like switched 12v, illumination, reverse, parking brake and vehicle speed sense.
All the wires needed to use your factory steering wheel controls are also included.
The harness above has an ISO connector instead of bare wires on the end. This harness wil lconvert the ISO connector so it will go straight into some radios without cutting a single wire. Check the google sheet on this products page to see if your radio is compatible.
Use the list below to figure out which one you need.
A radio mounting kits hold the radio in place and fills the gaps around the radio for a factory finish. Our kits are made of a thicker plastic than most of our competitors and we also have 3 different color options to match your interior.
We have two different styles. Our standard kit and one that holds our MIC-VW07-FACE
This is a custom microphone designed for the dash kit above.
You aftermarket radio is going to have a different AM/FM antenna connection. A converter is needed. The converter will also power you antenna booster through the blue wire.
Radios that have two cables
-Cars that have a radio with a “LOAD” button on the top left hand corner
-Cars with MFD2 Navigation radio
Radios have have one cable
-Cars that have a radio with a “mix” button on the top left hand corner.
This part is made to fit in your factory microphone location. Not only will you get better sound quality but since it is mounted behind the factory panel you will not have to see an ugly mic hanging off your headliner.
If you are adding Sirius XM you can reuse your factory antenna.
Golf, GTI, R32 and Rabbit the green SiriusXM antenna connector is located under the passenger seat.
Jetta & GLI had the green SiriusXM connector under the rear window in the trunk. The tuner is usually mounted to top of the trunk.
If you had factory navigation you can reuse your factory navigation antenna with you new radio. Most wireless carplay radios require a GPS antenna connection.
Our main harness has a reverse wire to tell your radio that you are in reverse. This wire does not have enough power to power a camera. If you connect a camera you will blow up the little box and void your warranty. This harness grabs power from the main wire and used our weak signal as a switch.
If you had a factory CD changer (MFD2 Navigation radios) or the iPod dock between the seats you can replace it with this pocket to give you extra storage.
This is used to replace the factory iPod dock, CD changer or Audi Music Interface AMI with a storage bin.
These tools come in handy when removing the cars interior trim.
Video on how to use the pocket to replace you factory iPod dock of CD changer. The video is in a newer Volkswagen but the hole is the same.
60 day return window
We ship to most countries
Credit Card - PayPal - Apple Pay - Google Pay
