This module is a complete plug and play interface that has the inputs for a rear and front camera.
Rear backup camera input. Switches the factory screen to reverse camera video while car is in reverse.
Front camera input. Turns on the front camera after the car switches out of reverse until the car goes above 10 MPH.
Front camera video input Connect the front camera video signal to this. Make sure to tape them together.
Reverse camera video input Connect the rear camera video signal to this. Make sure to tape them together.
Front camera 12V Use this to power the front camera.
Rear camera 12V Use this to power the rear camera only when in reverse.
ACC power Output Use this to power the rear camera at all times the car is on. When using Rear camera 12V to power the rear camera you can see black for a half second while the camera powers up. When connecting to this wire for power for the rear camera that does not happen but since the camera is on at all times but the life of the camera will be shortened. This wire can also be used when a camera requires Key 12V and reverse input (rear camera 12V).
GND Use this to ground you camera. We recommend running the front camera into the car and using this wire. For the rear camera we recommend grounding in the trunk but you can also run a wire from the trunk and use this wire.
Dip 1 Does the car have a factory rear cam?
Dip 2 Are we installing an aftermarket front camera?
Dip 1 Are we adding an aftermarket backup camera?
Dip 1 Is this a Q5
BUC-VW11 – Factory style backup camera that replaces your factory hatch/trunk handle while keeping the handle functioning.
This unit works with the cars below that have the radio controls on the dashboard and not down by the shifter.
Audi Q5/SQ5 2009-2017 All Cars