ย
The harnesses below have an ISO connector instead of bare wires on the end of them.ย This plug and play converter will go straight into some radios without cutting a single wire.ย Check the google sheet on this products page to see if your radio will connect directly of of you will need to buy a converter to do a plug and play easy peasy installation.
Use the list below to figure out which one you need.
If you order the SRWH-VW07-B below you will need to order one of these programmers in order to tell it what radio brand you are installing.ย Super easy programming.ย Just plug it in. No computers, Nintendo secret codes or flashing lights.
This harness connects to your factory wiring and provides the wires needed to install an aftermarket radio.ย Some of the wires needed to install an aftermarket radio are communicated through CAN bus. The small box is a CAN bus translator. The following wires are transmitted from the car to the radio through computer signals: Swithched12v, Illumination, Reverse, Parking brake and Vehicle Speed Sense. the small box reads two twisted wires CAN+ and CAN- and translates them into analog signals your new radio can read.ย It also translates the factory steering wheel controls into a signal your new radio can understand.
Coming soon
ย
This part is made to fit in your cars factory microphone location.ย Not only will you get better sound quality but since it is mounted behind the factory panel you will not have to see an ugly mic hanging off your headliner.
We are still looking for a car to make this.
If your car had a factory navigation radio your car has a factory GPS antenna.ย This adapter allows you to use the antenna on the roof for better signal.ย (many radios without built in GPS use a GPS antenna to improve navigation through your phone so check your radio.)
Not available yet
These tools come in handy when removing the cars interior trim.
We are still looking for a car to make these videos.